![]() ![]() The ambient light reading, a feature of this software, was moderately low which was good for all my monitors. ![]() I ended up with a fluorescent bulb of 5800 Kelvin of the lowest wattage I could find, 20 watts, in a lamp on the floor and shining to the ceiling. While working with the Spyder3, I did extensive testing on lighting for my room. When I checked Preferences and, then, AdvancedSettings, I found the default to be Advanced. These are accessed from the Preference file under Go on the toolbar. The Spyder3 can run at three different levels- Basic where there are few options, Classic where there are some, and Advanced which includes the ability to use curves, etc. The base can be screwed into the head of a tripod when calibrating a screen. It comes with a removable suction cup for LCD monitors although it also can be used on a CRT in that form. It comes on a stand which is used for storage and reading and monitoring ambient light. The Spyder3 has been made smaller with a larger meter reading area. Again this is to be expected for many reasons. When the brightness and contrast were set on default (only brightness on the laptop- no control for backlight) they were much brighter than on the CRTs. However, we are not talking a lot of difference. The image I used for testing looked brighter on the laptop and LCD than on the CRTs, but that was to be expected. Both these color castes were immediately corrected in calibration. The LCD had a color cast as did the laptop. ![]() I had calibrated the CRTs previously by hand and the differences were not very visible. I tested the software on 3 CRTs, an LCD, and a relatively new Dell laptop. In this review, I will discuss monitor calibration. It also includes information on the Spyder2Express™. Since one can purchase different configurations, below is a comparison chart. To create printer profiles one uses the the Datacolor 1005™ Spectrocolorimeter and the Spyder3Print software. The Elite version has more features than the Pro version even though the Colorimeter hardware is the same. There are two versions of Software for the Colorimeter, which is used to calibrate the monitor. In addition, the software is the Elite software. The Studio package contains both hardware and software for performing monitor calibration and for creating printer profiles. In this review I will be discussing monitor calibration only. I wrote a review about the ColorVision's Spyder2PRO and PrintFIX PLUS last year. ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |